Don’t take heed to any of the fools telling you “it gained’t work.” They’re incorrect and don’t have any clue what they’re speaking about. THE MAX SIZE FOR ANY INTERNAL HDD OR SSD is 2TB. ANYTHING OVER 2TB WILL NOT WORK.
Now, to repair the problem of neither drive being detected, you’ll must obtain and comply with the directions. For those who do all the pieces it says proper, you’ll have a functioning system once more.
Newest Xbox OS
Laborious Drive Prep Batch Recordsdata
Boot Animation Recordsdata
The Laborious Drive Prep Batch Recordsdata embrace the directions you’ll must comply with to get both the unique HDD or the SSD formatted and setup for use by the Xbox. The one steps that aren’t included are for the precise Xbox OS. You will want to comply with this:
There are a couple of extra steps you must full BEFORE you energy on the Xbox. Again in your PC, copy the Xbox One Working System information to a USB stick and join this to your Xbox.
Join the facility and HDMI cable to your Xbox, after which maintain energy the Bind (sync button) and Eject buttons on the entrance of the Xbox. Whereas nonetheless holding down the Bind and Eject buttons, faucet the facility button – hold holding down the Bind and Eject buttons.
You’ll hear one beep and the display will present in secure mode, hold holding down the Bind and Eject buttons and you’ll hear an extra two beeps.
After you have heard THREE beeps, you may launch the Bind and Eject buttons.
Your Xbox One will begin rebuild the BIOS (or NAND) on the motherboard and very quickly in any respect, you should have a working Xbox One once more!
I did retype most of this to phrase it higher however I did reference and replica some strains from:
Console Remedy’s Information on Changing Xbox HDDs
I additionally wish to make clear one thing. You completely must put the case again on the system while you’re accomplished. You’ll lose efficiency because the system will run hotter even being opened up. With the Xbox One S, the fan pushes air out of the highest grate as a substitute of pulling it into the console just like the newer fashions. The case creates a seal, a vacuum, for the fan to pump air out. With the case off, all it’s doing is solely cooling the warmth sink. The remainder of the chips and capacitors will not be being actively cooled as they need to. I’ve watched your video a couple of occasions and it appears to be like that you’re utilizing an SSD that’s in an exterior enclosure. You will want to take away the bodily SSD from the plastic enclosure as a way to mount it within the bracket for the Xbox.
It’s actually not a troublesome course of and may take no time in any respect. I want you luck! Preserve me up to date as to the way it goes as effectively. I’ll make the time to remark once more should you want any additional help.
Edit: there may be additionally a good video tutorial you may comply with right here:
YouTube
Edit #2: Whilst you have the Xbox opened, I might suggest changing the thermal paste should you haven’t already.
There’s loads of guides on eradicating the warmth sink and even tearing down the entire console, so I gained’t hyperlink them. However should you haven’t accomplished it already, get some Noctua NT-H1 Thermal Paste and use some 91% isopropyl or grain alcohol and Qtips to scrub the previous paste off the warmth sink and APU and exchange it with new paste.
You will notice a large efficiency acquire, a lot so, that will probably be like utilizing the system the primary day it got here out in 2016.
I might additionally extremely suggest shopping for the Xbox Fan Accelerator. This may enhance the velocity of the fan by about 50% of the velocity set by the console. This helps hold your console cooler and subsequently much less prone to develop issues as a consequence of overheating.
And eventually, should you actually wish to go the additional mile to squeeze out each final drop of efficiency after doing all the pieces else above, then purchase this Xbox One S Cooling System from Amazon. I’m not saying it’ll enhance your system efficiency massively, however it’ll most likely provide you with a couple of 5-10% efficiency acquire. Basically you’d by no means see body drops once more. Plus, protecting the system as cooled off as attainable means all the pieces will load and run as quick because it bodily can.
I actually hope this helps! And don’t take the daring textual content as me “yelling or nagging,” I merely needed to make sure these have been learn 😄
Edit #3: I used to be incorrect concerning the velocity distinction. It is 4am and I am a little bit toasted, I apologize.
